Tips In Inspecting Your Sump Pump’s Performance

sump pump inspection

source: http://www.mikesplumbing.com/

Sump pumps are pretty much automatic electrical tools that safeguard our basements from moisture invasion and eventual flooding. They are usually placed below the basement foundation or underground room floors to eliminate rising effluent or ground water, as well as surface overflow before it has a chance to leach into our home’s foundation. Collected ground water can trigger internal damage and support the growth of rot, mildew, and molds. These pumps must be kept in good condition and prepared with all necessary mechanisms in order to ensure their optimal performance.

You should check for the following:
An installed check valve.

This very important mechanism is the same size as the system’s discharge pipe and typically has a distinctive paint. This valve must be set up to stop ground water in the discharge pipe from flowing back into the sump pit when the device suddenly shuts down. If this valve is not installed, the pump will be overloaded to be able to remove the same amount of water, which may give pointless tension to the system. A check valve can also avert the likelihood that a discharge line linked to an external body of water will backflow into your sump pit.

If there is an alarm.

Sump pumps can have burnt fuse, lose energy, become blocked or lopsided, or break down in a variety of ways. It is important to have an alarm that will indicate water accumulation. These alarms can alert owners of overflowing so that it can be fixed before water destruction happens. These alarms are essential in homes that are unoccupied for extended times. Homeowners should consider that while an alarm can be beneficial, it is not a necessity.

If there is a secondary power supply.

During heavy storms and downpours, power outages often happen. This can render your sump pump to be useless when it is needed the most. Because of this, mixed with the failure to start related to GFCIs, all sump pumps should have a backup battery or electrical source to depend on. A pump powered by a battery or the home’s water pressure can also be installed as a backup. Again, this step is not required, but is highly recommended.

The presence of a ground fault circuit interrupter (GFCI).

There is extensive dispute among sump pump inspectors regarding whether or not a sump pump should be joined to it. It is likely that a GFCI can avert electric hazards, but it is questionable that a sump pump will electrify water in the first place. It is much more possible that a GFCI will falter during safe circumstances and disable the sump pump when it is crucial. A sump pump is among the most significant of all appliances, and it being shut off could permit terrible building destruction.

 Inspecting Your Sump Pump’s Performance

source: www.draincom.com

The pit size must be checked.

Your home should have a pit that is large enough for the installation of a sump pump. The sump pit need not be built from any specific substance, as long as it is sturdy and can give enduring upkeep for your pump. However, it has to be sizable enough to permit the pump to operate efficiently. For most basements, the sump pit should be greater than 2 feet in depth and should have a width of 1.5 feet. One of the most usual explanations why sump pumps break down and eventually fail is that the automatic float switch gets lodged because the pit is too restricted.

The sump pit should have a cover.

This is done to protect the sump pump from debris or large stones, as well as to prevent moisture from dispersing into the basement or foundation.

The discharge or output location.

All sump pump systems should be connected to a proper discharge spot. All water must be released at least 20 feet from the home. The drained water must not empty back into the pit as this will cause excessive pressure on the pump and can destabilize the foundation. The drained water must also never drain into someone else’s property without their consent or knowledge.

Following these sump pump tips and tricks in inspecting your sump pump system can save you from experiencing problems at a time when you need your pump to work most.

Watch this cool sump pump tips video, and read more tips here.

.

Leave a Comment:

Popular posts